A Beginner’s Guide To Hitting Irons In Golf

It’s proven that all golfers ideally like to hit a drive off the tee and through the treetops towards the targeted hole. It’s safer to perform long drive together with some company, nevertheless long drives don’t make a sense if you cannot even sink a putt. Long shots with a wood is not as significant as performing a short shot with an iron. This kind of shot might seem simple but, to the untrained golf player, it can be the most challenging shots to play. This article will provide some good info on how to hit irons efficiently when golfing.

Step #1: Position of the Body and Right Posture

The proper set up of the body like proper posture as well as alignment is the initial step to an effective hit. The most common error made by most newbie golfers is bending of the body. An untrained golf player will bend from the back over the club instead of at the waist. The swing trajectory of the ball would be affected and you will suffer a great deal of muscle pain at the back due to excessive use. Sustain a straight back while playing golf but not rigid. Tilt through the waist allowing for swing through the hips. You should keep your body in an even position in your feet to keep the balance of the body through the swing.

Step #2: The Placement of the ball

Ball placement is commonly neglected in setting an iron shot. As essential as long drives, short shot position should also be considered by golfers. When we discuss the ball placement, we refer to the position in accordance with your body. The ball being not farther back on the sternum and not far enough beyond your left armpit is the appropriate ball and body placement. One mistake beginners make is playing the shot too far forward leading to poor slices and putts. Attempt to hit the ball again and this time with your sternum straightened, if the ball heads into the ground when hit.

Step #3: Executing a Takeaway Position

The manner wherein the club is retracted and hit through is called takeaway position. The takeaway position is critical to get a great swing in a play and also the success it will make. The tactic used when hitting with an iron is the 2-8-2 rule. The first Two in the rule is the first 2 inches in a takeaway in which the club travels straight back. It is important to move the body (arm, legs and shoulders) in sync. The “8” refers to the eight inches when in the club curves in an upward direction but without moving the wrists. Finally, at the twelfth inch, the wrist turns placing the shaft horizontal to the ground. The hands must level to the shoulder height and also the shoulder must be tight. After forming this takeaway, follow through along the target line and engage the ball with a square iron face.

Step #4: Consider The Course

Obviously, while the set up and follow through of the swing are both very important, it is also vital to take into account the layout. Any changes while performing a swing or even takeaway, will be due to the surface of the ground where it is being performed. When the ball is to be played on a downhill slope, it’s always best to complete a downswing at the point where the ball will fall towards the hole. If the ground is green and has a slight downhill slope, a slight curve would be great to allow gravitational pull. It’s best to eliminate any obstructions to have a greater shot.

The post A Beginner’s Guide To Hitting Irons In Golf appeared first on Golf Ponderosa.

http://ift.tt/2cLSkzZ

Advertisements

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s